- Harness and connector
- Television camera assembly
- Navigation receiver assembly
| Last Modified: 11-29-2007 | 1.6 C | |
| Service Category: Audio/Visual/Telematics | Section: Navigation/Multi Info Display | |
| Model Year: 2008 | Model: Sequoia | Doc ID: RM000001WU102BX |
| Title: NAVIGATION / MULTI INFO DISPLAY: NAVIGATION SYSTEM: DESCRIPTION (2008 Sequoia) | ||
|
DTC |
5C-40 |
Camera Picture Error |
DESCRIPTION
|
DTC Code |
DTC Detection Condition |
Trouble Area |
|---|---|---|
|
5C-40 |
Synchronous signal from camera cannot be transmitted. |
|
WIRING DIAGRAM
INSPECTION PROCEDURE
HINT:
After the inspection is completed, clear the DTCs
.
PROCEDURE
|
1. |
CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER - TELEVISION CAMERA) |
|
(a) Disconnect the I7 navigation receiver assembly connector. |
(b) Disconnect the V17 television camera assembly connector.
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
|
Tester Connection |
Condition |
Specified Condition |
|---|---|---|
|
V17-4 (CB+) - I7-24 (CA+) |
Always |
Below 1 Ω |
|
V17-3 (CGND) - I7-21 (CGND) |
||
|
V17-2 (CV+) - I7-22 (V+) |
||
|
V17-1 (CV-) - I7-23 (V-) |
||
|
V17-4 (CB+) - Body ground |
Always |
10 kΩ or higher |
|
V17-3 (CGND) - Body ground |
||
|
V17-2 (CV+) - Body ground |
||
|
V17-1 (CV-) - Body ground |
(d) Reconnect the navigation receiver assembly connector.
(e) Reconnect the television camera assembly connector.
|
|
2. |
INSPECT NAVIGATION RECEIVER ASSEMBLY (CA+ VOLTAGE) |
|
(a) Measure the voltage according to the value(s) in the table below. Standard Voltage:
|
|
|
|